In a message dated 2/4/2002, Chris Maxwell writes:
> What would happen (assuming 60950) if you had AC on the component side > of a board and SELV on the solder side. (assuming that any through holes > were properly cleared out). > Hi Chris: That usually works out fine, since the board is treated as solid insulation. The minimum thickness of solid insulation for supplementary or reinforced insulation is 0.4 mm (about .017"). Most boards are much thicker than this. Joe Randolph Telecom Design Consultant Randolph Telecom, Inc. 781-721-2848 http://www.randolph-telecom.com
