A standard can not remove the requirement for harmonics and flicker testing
because 61000-3-2 and 61000-3-3 are family standards unto themselves (all
equipment equal to or less than 16 amps)..
Bob Heller
3M EMC Laboratory, 76-1-01
St. Paul, MN 55107-1208
Tel: 651- 778-6336
Fax: 651-778-6252
=========================
"Gordon,Ian"
<Ian.Gordon@boced
wards.com> To
Sent by: "'IEEE EMC & SAFETY PSTC'"
emc-pstc@LISTSERV <[email protected]>
.IEEE.ORG cc
Subject
11/09/2005 04:02 Harmonics and flicker
AM
All
Is it necessary to show compliance with harmonics and flicker requirements
for products even though the product standard applied specifically omits
this?.
My concern is that EN61326 requires these measurements for Class B
equipment
but specifically does not for Class A equipment.
Thanks
Ian Gordon
***********************************************************************
The information contained in this email and any attachments may be
confidential and is provided solely for the use of the intended
recipient(s). If you are not the intended recipient, you are hereby
notified that any disclosure, distribution, or use of this e-mail, its
attachments or any information contained therein is unauthorised and
prohibited. If you have received this in error, please contact the sender
immediately and delete this e-mail and any attachments.
No responsibility is accepted for any virus or defect that might arise from
opening this e-mail or attachments, whether or not it has been checked by
anti-virus software.
-
This message is from the IEEE Product Safety Engineering Society
emc-pstc discussion list. Website: http://www.ieee-pses.org/
To post a message to the list, send your e-mail to [email protected]
Instructions: http://listserv.ieee.org/listserv/request/user-guide.html
List rules: http://www.ieee-pses.org/listrules.html
For help, send mail to the list administrators:
Scott Douglas [email protected]
Mike Cantwell [email protected]
For policy questions, send mail to:
Jim Bacher: [email protected]
David Heald: [email protected]
All emc-pstc postings are archived and searchable on the web at:
http://www.ieeecommunities.org/emc-pstc
-
This message is from the IEEE Product Safety Engineering Society
emc-pstc discussion list. Website: http://www.ieee-pses.org/
To post a message to the list, send your e-mail to [email protected]
Instructions: http://listserv.ieee.org/listserv/request/user-guide.html
List rules: http://www.ieee-pses.org/listrules.html
For help, send mail to the list administrators:
Scott Douglas [email protected]
Mike Cantwell [email protected]
For policy questions, send mail to:
Jim Bacher: [email protected]
David Heald: [email protected]
All emc-pstc postings are archived and searchable on the web at:
http://www.ieeecommunities.org/emc-pstc
