Ian, Is it necessary to apply both air & contact discharges to equipment? I read it as: the contact discharge is applied to the conductive surface and the air discharge is applied to non-conductive surfaces.
I also know that I have yet to test air discharge without inadvertently discharging to the conductive surfaces a few times. Michael Sundstrom Electronic Lab Analyst Overhead Door TREQ Center, Dallas [email protected] OFC: 214-579-6312 CELL: 940-390-3644 KB5UKT ----- Forwarded by Michael Sundstrom/OHD/ODC on 05/18/2009 07:56 AM ----- "Gordon,Ian" <[email protected]> 05/18/2009 06:09 AM Please respond to "Gordon,Ian" <[email protected]> To [email protected] cc Subject [PSES] ESD testing All Is it necessary to apply both air & contact discharges to equipment given the following?: Looking at 61000-4-2 I believe the critical part is the first paragraph of section 7 ".Test set-up". .....application of discharges to the EUT in the following manner: a) contact discharge to the conductive surfaces and coupling planes; b) air discharge at insulating surfaces. it does not say for air discharge at insulating AND conductive surfaces. The table in section. 8.3.1 is just for conductors but is essentially a restatement of the above. I cannot see any other part of the spec that implies the opposite. Ian Gordon --- --- --- --- --- --- --- --- --- --- --- --- --- The contents of this email and any attachments are confidential and are provided solely for the use of the intended recipient(s). If you are not the intended recipient, you are hereby notified that any copying, disclosure, distribution, or use of this e-mail, its attachments or any information contained therein is unauthorized and strictly prohibited and you should please contact the sender immediately and delete this e-mail and any attachments from your system. No responsibility is accepted for any virus or defect that might arise from opening this e-mail or attachments, whether or not it has been checked by anti-virus software. - This message is from the IEEE Product Safety Engineering Society emc-pstc discussion list. To post a message to the list, send your e-mail to <[email protected]> All emc-pstc postings are archived and searchable on the web at: http://www.ieeecommunities.org/emc-pstc Graphics (in well-used formats), large files, etc. can be posted to that URL. Website: http://www.ieee-pses.org/ Instructions: http://listserv.ieee.org/request/user-guide.html List rules: http://www.ieee-pses.org/listrules.html For help, send mail to the list administrators: Scott Douglas <[email protected]> Mike Cantwell <[email protected]> For policy questions, send mail to: Jim Bacher: <[email protected]> David Heald: <[email protected]> - This message is from the IEEE Product Safety Engineering Society emc-pstc discussion list. To post a message to the list, send your e-mail to <[email protected]> All emc-pstc postings are archived and searchable on the web at http://www.ieeecommunities.org/emc-pstc Graphics (in well-used formats), large files, etc. can be posted to that URL. Website: http://www.ieee-pses.org/ Instructions: http://listserv.ieee.org/request/user-guide.html List rules: http://www.ieee-pses.org/listrules.html For help, send mail to the list administrators: Scott Douglas <[email protected]> Mike Cantwell <[email protected]> For policy questions, send mail to: Jim Bacher <[email protected]> David Heald <[email protected]>
