At least two test labs have written papers about use of ITE component power supplies in equipment scoped for 61010. The Emperor's search engine should suffice.
Am very careful about recommending use of my employers ITE-certified stuff in customer's test equipment. The 61010 3d edition has some significant changes that could affect requirements not addressed in a 60960 CB report. So it depends on the end-use equipment construction, ratings, and power supply construction. Brian From: Amund Westin [mailto:[email protected]] Sent: Tuesday, December 16, 2014 2:02 PM To: [email protected] Subject: [PSES] 60950-1 PSU in a 61010-1 product The final product will be tested according to IEC/EN61010-1 (measurement, control, and laboratory use). To power this product, an open frame AC/DC power will be uses and it holds a CB certificate according to IEC/EN60950-1. Will we run into trouble with this configuration? In the past, the final product was powered by a medical PSU (IEC/EN60601-1). I would like to switch to the 60950-1 PSU if possible …. #Amund - ---------------------------------------------------------------- This message is from the IEEE Product Safety Engineering Society emc-pstc discussion list. To post a message to the list, send your e-mail to <[email protected]> All emc-pstc postings are archived and searchable on the web at: http://www.ieee-pses.org/emc-pstc.html Attachments are not permitted but the IEEE PSES Online Communities site at http://product-compliance.oc.ieee.org/ can be used for graphics (in well-used formats), large files, etc. Website: http://www.ieee-pses.org/ Instructions: http://www.ieee-pses.org/list.html (including how to unsubscribe) List rules: http://www.ieee-pses.org/listrules.html For help, send mail to the list administrators: Scott Douglas <[email protected]> Mike Cantwell <[email protected]> For policy questions, send mail to: Jim Bacher: <[email protected]> David Heald: <[email protected]>
