Yes Sven you are dead right, the mistake I was making was trying to do it using Nero SmartStart which would have been alright if I had closed the window that appears and gone straight to Recorder then Burn Image. However I did persivere and eventually work it out. I have now had Ubuntu+EMC2 installed on my PC for a couple of days and all is working well. However the configuration procedure for a specific machine seems rather more complex than it is for TurboCNC. I am using the Xylotex driver board on a bench mill, I found the Xylotex configuration in the samples but can't seem to get it to run it always seems to load with the standard pin outs I did try removing these files and just leaving the Xylotex and metric files in the folder but this did'nt work either. Any help from you guy's would be very welcome.
Thanks Rod. ----- Original Message ----- From: "Sven Mueller" <[EMAIL PROTECTED]> To: "Enhanced Machine Controller (EMC)" <emc-users@lists.sourceforge.net> Sent: Tuesday, May 22, 2007 7:52 PM Subject: Re: [Emc-users] How to > Rod Welland wrote on 20/05/2007 17:28: > >>> I think you hit it on the head Ray Nero has not created a boot disc >>> there is only one file on the CD and not the 9 or so I should be >>> seeing. So I,m going to download another CD burning prog form the >>> internet today and have another go. > > > You probably created a new project in Nero and added the file you > downloaded. Instead, you should select "burn image" (or similar) from > the recorder menu item. In the file dialog that appears, you should then > select the image you downloaded from linuxcnc.org. > > regards, > Sven > > > ------------------------------------------------------------------------- > This SF.net email is sponsored by DB2 Express > Download DB2 Express C - the FREE version of DB2 express and take > control of your XML. No limits. Just data. Click to get it now. > http://sourceforge.net/powerbar/db2/ > _______________________________________________ > Emc-users mailing list > Emc-users@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/emc-users > > ------------------------------------------------------------------------- This SF.net email is sponsored by DB2 Express Download DB2 Express C - the FREE version of DB2 express and take control of your XML. No limits. Just data. Click to get it now. http://sourceforge.net/powerbar/db2/ _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
