You do need multiple scales for pulse coder at .001,.010,.1 for touch off tools
or using in manual for milling.
Dave Engvall <[EMAIL PROTECTED]> wrote: Hi all,
Step one is now done; the pulsecoder is connected to channel 03
encoder on the stg board and it works.
400 counts /rev. This would scale nicely to 0.100"/rev.
I have a nice front panel switch for X, Y, Z ,B. If I use B as a not
enable then the other positions select axis and
enable at the same time. The pulsecoder itself is bidirectional so I
don't need a direction bit.
Now I need some help on how to set up a HAL connection for this.
Pointing to a relevant example on the wiki would be a good start.
At least for now I don't see a need have multiple scales related to a
pulse.
Dave
-------------------------------------------------------------------------
This SF.net email is sponsored by: Microsoft
Defy all challenges. Microsoft(R) Visual Studio 2005.
http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/
_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users
-------------------------------------------------------------------------
This SF.net email is sponsored by: Microsoft
Defy all challenges. Microsoft(R) Visual Studio 2005.
http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/
_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users
