On Monday 03 December 2007, Kirk Wallace wrote: >On Mon, 2007-12-03 at 13:00 -0500, Gene Heskett wrote: >> On Monday 03 December 2007, Emory Smith wrote: >> >Unless you already have some sort of RS232 receiver/decoder for those > >... snip > >> >7 outputs to drive 3 home LEDs, 3 limit LEDs and a Xen LED. >> > >> >HTH, >> >Emory >> >> Hi; I'm considering adding enough ports to run my lathe too, and looking >> at this card >> <http://www.tigerdirect.com/applications/searchtools/item-details.asp?EdpN >>o=1003992> >> >> and the 4 axis xylotex 425 kit to do it with. Probably around $30 >> delivered. The xylotex kit I already have so that's not a problem. Has >> anyone here any experience with such a beast as this dual port card might >> be? >> >> Thanks. > >I have a two port PCI card that appears to be similar. I seem to recall, >lspci reports one entry with additional memory space blocks. I just >guessed at the first and fourth block for the driver parameters, and it >worked just fine. No magic really.
Thanks. Looking again at that GMR sensor in your last post, I'm surprised its only good to 10 kilohertz. That is pretty slow and would certainly be over powered by looking at the head gear in my small lathes spindle. Odd too since this technology is now being used in terabyte disk drives at several hundred megabytes per second read speeds. Thanks. -- Cheers, Gene "There are four boxes to be used in defense of liberty: soap, ballot, jury, and ammo. Please use in that order." -Ed Howdershelt (Author) Q: Why did the lone ranger kill Tonto? A: He found out what "kimosabe" really means. ------------------------------------------------------------------------- SF.Net email is sponsored by: The Future of Linux Business White Paper from Novell. From the desktop to the data center, Linux is going mainstream. Let it simplify your IT future. http://altfarm.mediaplex.com/ad/ck/8857-50307-18918-4 _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
