Alan Condit wrote: > Jeff, > > I tried to use stepconf and couldn't get it to work. > I am using emc2 2.2.2. I have a configuration that works so I know that there > is > not a problem with my hardware. I am using a CandCNC miniIO BOB which uses the > Xylotex pinout. All three drives are enabled by the same signal. All three > drives are the same (SS2000MD4 Superior Electric). All three leadscrews are > 5tpi > and all three motors are halfstep and direct drive. > > The funny thing is that the z axis works but the x and y don't work in > stepconf. > When I try to test either the x or the y, they seem to start to move (they > lockup) but don't move. > > I would like to attach my good ini file (stepper_in_mill.ini) and good hal > file > (candcnc_pinout.hal) as well as the ini file (my_mill.ini) and hal file > (my_mill.hal) from stepconf and see if you can tell me what is going wrong. > > I would also like to commit my hal file candcnc_pinout.hal as it uses slightly > different pinouts for things like charge pump/enable, estop, home and limits. > This might help anyone else using a CandCNC BOB to get running quicker. > > Thanks, > Alan >
I'd suggest pastebin for the files. Don't send big attachments to the list. I'd also suggest running diff and posting the diff (on list if short, at pastebin if long). Since you have a working config, seems like you should be looking to see what is different. Regards, John Kasunich ------------------------------------------------------------------------- SF.Net email is sponsored by: Check out the new SourceForge.net Marketplace. It's the best place to buy or sell services for just about anything Open Source. http://sourceforge.net/services/buy/index.php _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
