Jeff Epler <[EMAIL PROTECTED]> writes:
 
> So here's what I would try: Edit my-mill.ini to set BASE_PERIOD to
> 150000 so that the delay can actually be 25000ns.  If that still doesn't
> work, also edit my-mill.hal to increase the delay above 25000ns.
> Perhaps your break-out board creates an additional timing requirement
> that you haven't accounted for yet.
> 
> There is no way to direct stepconf to produce a non-doublestep
> configuration.
> 
> Jeff

I will give your suggestions a try.  However, it would be great if stepconf (or
something like it) could directly produce a non-doublestep configuration. 
Having the ability to test the configuration in the program would be really
helpful to anyone trying to bring up a new cnc conversion.

Alan


-------------------------------------------------------------------------
SF.Net email is sponsored by: 
Check out the new SourceForge.net Marketplace.
It's the best place to buy or sell services for
just about anything Open Source.
http://sourceforge.net/services/buy/index.php
_______________________________________________
Emc-users mailing list
Emc-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-users

Reply via email to