Alan Condit wrote:
> Jeff Epler <[EMAIL PROTECTED]> writes:
> 
>> One difference I spotted between the two ini files is that the
>> configured acceleration is higher in the stepconf file than in the
>> working file.
>>
>> Jeff
>>
> Jeff,
> 
> After testing my working config some more, I upped the acceleration on all 
> three
> axii in my working config, to match the acceleration in the stepconf files 
> that
> are not working, and everything runs fine with my working config files. So 
> that
> is not what is causing the problem.
> 

There must be something different between the generated files and the 
working files.  You will have to figure out what it is.  Once you know 
what the difference is, then Jeff can figure out if it is a stepconf 
error, or if you have something in your system that is beyond what 
stepconf is designed to do.

Stepconf is NOT an all purpose configuration generator - it is intended 
to cover a very popular class of simple configurations.

One idea just occurred to me...  while running the working config, open 
a shell and do a halcmd save (redirect to a file).  Then load the bad 
config and do the same.  The halcmd save should output most stuff in the 
same order each time, so diff can be used to find the differences.

Good luck,

John Kasunich

-------------------------------------------------------------------------
SF.Net email is sponsored by: 
Check out the new SourceForge.net Marketplace.
It's the best place to buy or sell services for
just about anything Open Source.
http://sourceforge.net/services/buy/index.php
_______________________________________________
Emc-users mailing list
Emc-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-users

Reply via email to