Hello, what aspects are you worried are not supported by emc2? The stepper drives are step/dir or up/down (both modes are supported by emc2). The timings are also fairly accurate described in the manuf. pdf, so I don't see any issues setting things up.
I would say the kit should work with emc2, but maybe you have more specific needs we should consider? Best regards, Alex Joni ----- Original Message ----- From: "Pella" <[EMAIL PROTECTED]> To: "Enhanced Machine Controller (EMC)" <[email protected]> Sent: Thursday, December 13, 2007 2:52 PM Subject: [Emc-users] microstepper driver support > Hi, I wanna buy this cnc kit > http://www.motioncontrolproducts.co.uk/product_info.php?cPath=5&products_id=57&osCsid=f2f7789e24151d24d72b40ae1b5e7df7 > but I don't know if it is supported by EMC2. > > Could you help me? > > Thx > Pella > > ------------------------------------------------------------------------- > SF.Net email is sponsored by: > Check out the new SourceForge.net Marketplace. > It's the best place to buy or sell services > for just about anything Open Source. > http://ad.doubleclick.net/clk;164216239;13503038;w?http://sf.net/marketplace > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users > ------------------------------------------------------------------------- SF.Net email is sponsored by: Check out the new SourceForge.net Marketplace. It's the best place to buy or sell services for just about anything Open Source. http://ad.doubleclick.net/clk;164216239;13503038;w?http://sf.net/marketplace _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
