Nope, it's this one: http://cvs.linuxcnc.org/cgi-bin/cvsweb.cgi/emc2/src/emc/usr_intf/axis/scripts/axis.py.diff?r1=1.143;r2=1.144;f=h
hmm, I just read my other email and it seems I forgot to tell you that you have to set the env AXIS_NO_HAL in order for AXIS to work on a machine without HAL. export AXIS_NO_HAL=1 /path/to/axis -ini axis-remote.ini Regards, Alex ----- Original Message ----- From: "Kirk Wallace" <[EMAIL PROTECTED]> To: "Enhanced Machine Controller (EMC)" <emc-users@lists.sourceforge.net> Sent: Friday, December 28, 2007 2:32 AM Subject: Re: [Emc-users] Remote GUI > On Wed, 2007-12-26 at 23:22 +0200, Alex Joni wrote: >> Hi all, >> >> I just managed to get AXIS to run remotely as a GUI. >> In order to do that I had to modify AXIS a bit, but I checked the changes >> into CVS. > ... snip > > I am not familiar with CVS. Is it rev 1.56 here?: > > http://cvs.linuxcnc.org/cvs/emc2/share/axis/tcl/axis.tcl > > -- > Kirk Wallace (California, USA > http://www.wallacecompany.com/machine_shop/ > Hardinge HNC lathe, > Bridgeport mill conversion, doing XY now, > Zubal lathe conversion pending) > > > ------------------------------------------------------------------------- > This SF.net email is sponsored by: Microsoft > Defy all challenges. Microsoft(R) Visual Studio 2005. > http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ > _______________________________________________ > Emc-users mailing list > Emc-users@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/emc-users > ------------------------------------------------------------------------- This SF.net email is sponsored by: Microsoft Defy all challenges. Microsoft(R) Visual Studio 2005. http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
