I want to add an EMC CNC controller to my bridgeport clone however, before I
start, I was thinking of retrofitting and installing ball screws.  I think I
have too much backlash in what I have now.  I have a taiwanese 10" x 50"
bridgeport cone with a M cast into the main casting.  So who sells zero
backlash ball scres that are atleast as accruate as +/- 0.0005/Ft and how
much would the setup cost me if I wanted to put it on my mill?

Thanks

WGB
-------------------------------------------------------------------------
This SF.net email is sponsored by: Microsoft
Defy all challenges. Microsoft(R) Visual Studio 2008.
http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/
_______________________________________________
Emc-users mailing list
Emc-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-users

Reply via email to