Kirk Wallace wrote: > On Sun, 2008-01-27 at 09:53 -0500, Stan Blosser wrote: > >>Dredging up a slightly old thread, but rather than start a new one... >> >>I'm in the design/planning stages of CNCing a Sieg X3 mill and will be >>using ball screws. At this point, I am planning to use Nook XPR
Snip >>Thanks, >>Stan > > > The only ideas I have come up with so far are, to use gauge blocks which > could get expensive in a hurry, and maybe laser interferometry like > here: If you have micrometer standards or can borrow them they work well. Set a small piece of angle iron in a Tee slot and set them in it, one against a stop and the others stacked and accesable to a DTI. Ed. ------------------------------------------------------------------------- This SF.net email is sponsored by: Microsoft Defy all challenges. Microsoft(R) Visual Studio 2008. http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
