On Mon, Feb 11, 2008 at 04:17:34PM -0800, Kirk Wallace wrote:
> I couldn't do the copy for some unknown reason, (I'll have to try harder
> later), but I did use "wire" in layer 21 to draw the outline, reran CAM
> job gerb274x.cam, gerbv'd the .plc file and every thing including the
> outline was there.

Yep, creating it from scratch is just as good.  :-)

> In my previous attempts I tried different CAM jobs and settings so
> it's hard to tell what I did wrong, but seems to work as expected now.
> Thanks

So far, I've chickened out, and just sent the board file, for them to
CAM, but I see that batchpcb needs it done.

> 
> and I like the silver plating, but Sparkfun's:
> 
> http://www.batchpcb.com/
> 
> is about half the price for three times the wait.

Thanks for that. It takes me so long to pack too much into too small a
board, that a small delay in manufacture wouldn't be noticed. Lower
prices might convince me to spread things out a bit, reducing the need
for heatsinking.

Erik

-------------------------------------------------------------------------
This SF.net email is sponsored by: Microsoft
Defy all challenges. Microsoft(R) Visual Studio 2008.
http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/
_______________________________________________
Emc-users mailing list
Emc-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-users

Reply via email to