Hi, I have a gantry type router made in California with a SoftServo versiobus (right now using Win2000), Ormec firewire servo drives and an Elte spindle (Yaskawa drive). It came with the SoftServo software, but nobody's very happy with it. Part of the reason is that the drives can't be tuned, and performance is less than satisfactory. I'm considering dumping the software for EMC2, and would like to know how difficult it will be to configure. The versiobus does all of the I/O right now, and most of the PLC stuff is ok the way it is. I imagine I'll have to redo the ladder once the new system is installed, but I need to know if I have to swap out any/all of the electronics. I didn't see any of the hardware on the EMC hardware list. I haven't started yet, but would like to soon.
Brian -- Brian W. Gilman Opera Medical Components www.operamedical.com T: 781-447-3933 F: 781-447-2660 C: 781-771-2284 This email is confidential to Opera Medical Components and intended only for the addressee. It may contain information which is covered by legal, professional, or other privileges. If you are not the intended addressee, or designee, you must not retain, disclose in any form, copy, or take any action in reliance on this transmission. If you have received this email in error, please notify the sender and delete this message. While we use virus protection, the recipient should check this email and any attachments for the presence of viruses. We accept no liability for any damage caused by any virus transmitted by this email. ------------------------------------------------------------------------- This SF.net email is sponsored by: Microsoft Defy all challenges. Microsoft(R) Visual Studio 2008. http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
