Thanks for the info. Just wanted to make sure PWM (or PDM) up/down was possible with Mesa boards. For the money, I knew the 7i43 was a good deal with 8 encoders/8 PWM outputs plus additional unused FPGA space compared with Pluto's 4/4. Sebastian and Peter, thanks for Mesa hal drivers.
Know I've got to figure out how deal with 50 pin IDC connectors, nice for clean Mesa board to board connections, but what a pain for homebuilt parts scrounging. I've got a butt load of old SCSI cables, cards and misc junk, so hopefully that will help with building stuff. I can't see spending $70+ for 50 pin screw connectors. Sam> I'm planning to build something similar to your h-bridge at http://www.cnczone.com/forums/showthread.php?t=25929. BTW, the Milwaukee Matic in your shop is a monster, nice! Keil -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Gene Heskett Sent: Thursday, March 20, 2008 8:13 AM To: Enhanced Machine Controller (EMC) Subject: Re: [Emc-users] Mesa 7i43 PWM Output mode On Thursday 20 March 2008, sam sokolik wrote: >Yes - this was strictly for the mesa card (I have both the pluto and mesa >card). Both pwmgen and the pluto have the option for up/down pwm. > >sam And thats what I get for not going back and re-reading the earlier parts of the thread, sorry Sam. -- Cheers, Gene "There are four boxes to be used in defense of liberty: soap, ballot, jury, and ammo. Please use in that order." -Ed Howdershelt (Author) <kira> Ada, the only language written to milspec. <Mikster> <shudder> ------------------------------------------------------------------------ - This SF.net email is sponsored by: Microsoft Defy all challenges. Microsoft(R) Visual Studio 2008. http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users ------------------------------------------------------------------------- This SF.net email is sponsored by: Microsoft Defy all challenges. Microsoft(R) Visual Studio 2008. http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
