> Gene Heskett wrote: > >> A bit rough on an obvious newbie, John. In this case, and reading >> between the >> lines, I'm guessing that the terminology and format of the questions >> stepconf >> is asking are in effect, swahili to the OP, they are quite concise >> because of >> the gui's limits. When I ran it the first time, there were several items >> I >> didn't get right as the wording was somewhat ambiguous. > > I'll admit I was a bit rough, and I apologize. But... > >> He will in time learn, if we are willing to help, but first we need to >> know >> which question the OP is attempting to derive the answer to. > > EXACTLY! > > He didn't say "I've done steps 1, 2, and 3, but I'm stuck on step 4". > He said "give me the numbers". And when John Thornton asked him "Which > number", he said "all of them". > > I am more than willing to try to help. But the person asking for help > has to put in some effort too. > > Regards, > > John Kasunich > > ------------------------------------------------------------------------- > This SF.net email is sponsored by the 2008 JavaOne(SM) Conference > Don't miss this year's exciting event. There's still time to save $100. > Use priority code J8TL2D2. > http://ad.doubleclick.net/clk;198757673;13503038;p?http://java.sun.com/javaone > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users >I've tried putting numbers in like 400 steps per rev .5 micro stepping and the machine only travels half the distance that you tell it to. Also the Y and Z axes run backwords and I can't figure out where to go from here. any help would be greatly appreciated.
------------------------------------------------------------------------- This SF.net email is sponsored by the 2008 JavaOne(SM) Conference Don't miss this year's exciting event. There's still time to save $100. Use priority code J8TL2D2. http://ad.doubleclick.net/clk;198757673;13503038;p?http://java.sun.com/javaone _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
