There is an example here http://wiki.linuxcnc.org/cgi-bin/emcinfo.pl?Hooking_Up_A_MPG_Pendant
while not an exact example of what you want it should get you close. Any when you work out the details please add it to the wiki page John On 25 May 2008 at 10:02, Dave Keeton wrote: > Looking at the integrators manual in the halui section I found the > following under Feed and Spindle override..... > > (S 32) halui.feed-override.counts - counts from an encoder for example > to change FO > > (S 32) halui.spindle-override.counts - counts from an encoder for > example to change SO > > The plan is to use the MPG to change the overrides. I have seen > this > done on other PC based controls. Is there an example somewhere on how > these are used? > > Dave > > > > ---------------------------------------------------------------------- > --- This SF.net email is sponsored by: Microsoft Defy all challenges. > Microsoft(R) Visual Studio 2008. > http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ > _______________________________________________ Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users > ------------------------------------------------------------------------- This SF.net email is sponsored by: Microsoft Defy all challenges. Microsoft(R) Visual Studio 2008. http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
