I should set the jumpers in the "UP" position in my case. It is because the encoder is RS-422 type, is it correct??
Howard > On Thu, 5 Jun 2008, Howard Chan wrote: > > No, you connect the A,/A B,/B and Z,/Z wires from the encoder to the 7I33T. > The 7I33T has the 3486 line reciever for the differential signals built in. > The 3486 chip on the 7I33T converts these differential signals to single > ended > TTL level signals for the 5I20. The 7I33T then connects these TTL level > signals to the 5I20 with a 50 conductor flat cable. > > You must also jumper the 7I33T for differential mode encoders (this is > described in the 7I33 manual) > > Peter Wallace > > > ------------------------------------------------------------------------- > Check out the new SourceForge.net Marketplace. > It's the best place to buy or sell services for > just about anything Open Source. > http://sourceforge.net/services/buy/index.php > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users > > ------------------------------------------------------------------------- Check out the new SourceForge.net Marketplace. It's the best place to buy or sell services for just about anything Open Source. http://sourceforge.net/services/buy/index.php _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
