Couple of simple questions I hope. First, is there a wiki on using the Wizard? I was trying to modify a configuration and the wizard would not proceed past the selection window. I could move through the directory and select the configuration directory but did not see anything to select. *NEVER MIND - Was just about to send when I reviewed my thoughts on the Stepconf and I now see the item to select! *
Second - When deciding upon the step rate, I assume that it the numer to put in the box is the denominator - correct? Such as 2 = 1/2 stepping? I am going with full stepping since I have poor latency on my box (38ns). I will hopefully clean this up later, but I would rather get this thing working rather than be a shop ornament. I tried to put a 1 in this space and when I ran the config - EMC failed to open. Changed that to 2 and it works (with a screwed up scale of course). Third, when I test an axis (such as the X) I lose steps. When I then open up EMC with the config made (ignoring the axis test earlier) it seems to run fine (except for my scale is off due to step selections. Finally, on the third page of the wizard, I select XYZ setup. When I get to the pinout page, I have to undo all the A axis pins. Seems to me, slecting the XYZ setup should eliminate the reference for these ahead of time (just a nit pick item here). Thanks. Brian ------------------------------------------------------------------------- This SF.Net email is sponsored by the Moblin Your Move Developer's challenge Build the coolest Linux based applications with Moblin SDK & win great prizes Grand prize is a trip for two to an Open Source event anywhere in the world http://moblin-contest.org/redirect.php?banner_id=100&url=/ _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
