On Sun, 2008-11-02 at 07:46 -0500, John Domville wrote: > Heinz Reimer, > Thanks for the input. I will check into the information you provided. > Seems a shame thought to have to use a counter weight on Z axis as the > system should have been designed to move it own weight. If you have any > pictures on the counter weight you used please send them to me. > > John Domville > > -----Original Message----- > From: Heinz Reimer [mailto:[EMAIL PROTECTED] > Sent: Saturday, November 01, 2008 10:57 PM > To: Enhanced Machine Controller (EMC) > Subject: Re: [Emc-users] Engrave-11 Z test at 50 percent > > [EMAIL PROTECTED] wrote:
> > and on each one of axis pages there is the following settings" > > > > Motor Steps per rev 200 > > Driver Micro Stepping 4.0 > > Max Velocity 1.0 in/sec > > Max Acceleration 30.0 in/sec. > > > > John I used a much lower accel. You might try 5 rather than 30. Rayh ------------------------------------------------------------------------- This SF.Net email is sponsored by the Moblin Your Move Developer's challenge Build the coolest Linux based applications with Moblin SDK & win great prizes Grand prize is a trip for two to an Open Source event anywhere in the world http://moblin-contest.org/redirect.php?banner_id=100&url=/ _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
