I ended up setting the acceleration to 10 and the velocity to .5 and
engrave-11 is
Working like a charm. I also selected 50% feed rate over ride in AXIS.
Now I need to do some research on engraving (routing) PCB foil paths.
John - Elmira N
-----Original Message-----
From: Jon Elson [mailto:[EMAIL PROTECTED]
Sent: Sunday, November 02, 2008 12:31 PM
To: [EMAIL PROTECTED]; Enhanced Machine Controller (EMC)
Subject: Re: [Emc-users] Engrave-11 Z test at 50 percent
Ray Henry wrote:
>
>>> [EMAIL PROTECTED] wrote:
>>> and on each one of axis pages there is the following settings"
>>>
>>> Motor Steps per rev 200
>>> Driver Micro Stepping 4.0
>>> Max Velocity 1.0 in/sec
>>> Max Acceleration 30.0 in/sec.
>>>
>>> John
>>>
>
> I used a much lower accel. You might try 5 rather than 30.
>
Holy COW! No wonder he is having problems, that is VERY fast
acceleration for a small machine.
(Just to clarify John's post, that 30 is actually 30 in/sec^2.)
Jon
https://lists.sourceforge.net/lists/listinfo/emc-users
-------------------------------------------------------------------------
This SF.Net email is sponsored by the Moblin Your Move Developer's challenge
Build the coolest Linux based applications with Moblin SDK & win great prizes
Grand prize is a trip for two to an Open Source event anywhere in the world
http://moblin-contest.org/redirect.php?banner_id=100&url=/
_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users
