I'm having some problems getting EMC to see the I/o on port P3 of m 5i23 I have 
P2 connect to a 7i33 and it seams to be work as I can run my motors and the 
display show movement. I have at this time six limit switch and four output 
wired up. The output are wired to a Opto 22 quad pack that is sink 5 volts to 
the OBIT+ pin of the 7i37 with the OBIT- tied to ground. I can ground the OBIT+ 
side of any channel and the opto units turn on and drives the AC Loads. So I 
know the Opto unit is good.

Donnie 

Attachment: m5i23.ini
Description: Binary data

Attachment: m5i23.hal
Description: Binary data

------------------------------------------------------------------------------
This SF.net email is sponsored by:
SourcForge Community
SourceForge wants to tell your story.
http://p.sf.net/sfu/sf-spreadtheword
_______________________________________________
Emc-users mailing list
Emc-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-users

Reply via email to