On Tue, 27 Jan 2009, Richard Acosta wrote:
> Date: Tue, 27 Jan 2009 01:15:18 -0200
> From: Richard Acosta <[email protected]>
> Reply-To: "Enhanced Machine Controller (EMC)"
> <[email protected]>
> To: "Enhanced Machine Controller (EMC)" <[email protected]>
> Subject: Re: [Emc-users] 7i43 and pinout.
>
> Hello again, there is something i'm missing, or i can't understand.
> Should i recompile EMC or hostmot after modifying that file?
If by "that file" you mean the .PIN file, no dont modify it:
.PIN files only document a specific firmwares pinout.
>
> I thougt i have seen a command to tell on runtime inside a .hal file
> where the encoder is connected and where the pwmgens.
>
No, The pinout of a specific firmware (.BIT file) is fixed. The only thing
that can be changed is deciding if a specific special function (like encoder
inputs or PWM outputs) is enabled on specific pins. If the special function is
not enabled, the pin(s) that it uses becomes available as GPIO.
Peter Wallace
Mesa Electronics
(\__/)
(='.'=) This is Bunny. Copy and paste bunny into your
(")_(") signature to help him gain world domination.
------------------------------------------------------------------------------
This SF.net email is sponsored by:
SourcForge Community
SourceForge wants to tell your story.
http://p.sf.net/sfu/sf-spreadtheword
_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users
