Let's see if i understood... I must watch that .pin file to know where to connect encoders and pwmgen ¿am i right?
(I know this is beyond my knowledge) If i disable a specific function on a pin and the pin becomes GPIO... ¿is this in any way usable?...¿or is just a "flag"? Thanks again, and again, and again. El 27/01/2009 01:40 a.m., Peter C. Wallace escribió: > On Tue, 27 Jan 2009, Richard Acosta wrote: > > >> Date: Tue, 27 Jan 2009 01:15:18 -0200 >> From: Richard Acosta <[email protected]> >> Reply-To: "Enhanced Machine Controller (EMC)" >> <[email protected]> >> To: "Enhanced Machine Controller (EMC)" <[email protected]> >> Subject: Re: [Emc-users] 7i43 and pinout. >> >> Hello again, there is something i'm missing, or i can't understand. >> Should i recompile EMC or hostmot after modifying that file? >> > > If by "that file" you mean the .PIN file, no dont modify it: > > .PIN files only document a specific firmwares pinout. > > > >> I thougt i have seen a command to tell on runtime inside a .hal file >> where the encoder is connected and where the pwmgens. >> >> > > No, The pinout of a specific firmware (.BIT file) is fixed. The only thing > that can be changed is deciding if a specific special function (like encoder > inputs or PWM outputs) is enabled on specific pins. If the special function > is > not enabled, the pin(s) that it uses becomes available as GPIO. > > Peter Wallace > Mesa Electronics > > (\__/) > (='.'=) This is Bunny. Copy and paste bunny into your > (")_(") signature to help him gain world domination. > > ------------------------------------------------------------------------------ > This SF.net email is sponsored by: > SourcForge Community > SourceForge wants to tell your story. > http://p.sf.net/sfu/sf-spreadtheword > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users > > ------------------------------------------------------------------------------ This SF.net email is sponsored by: SourcForge Community SourceForge wants to tell your story. http://p.sf.net/sfu/sf-spreadtheword _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
