2009/6/30 Graham Cowan <[email protected]>: > I needed to change a parallel port setting for coolant flood (torch on/off) > and now the motors turn very very slowly, maybe even just bounce a little.
Not exactly science, but you could try inverting the step signals in stepconf. I found this worked for me (though what I probably needed to do was to change the mark/space ratio or something like that) > If I use my old configuration, EMC will load fine with no problems, but when > I try to operate the motors, they whine like they are moving but barely even > make one or two steps. This might be due to EMC trying to move them too fast. Have the accelleration and maximum speed changed? Can you jog at low speed at all? -- atp ------------------------------------------------------------------------------ _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
