Ok, thank You for a suggestion! I shall check tomorrow, if that difference is constant or not and i also will check the SCALE parameter. I think that it should be the same, but i am not 100% sure.
Viesturs 2010/5/25 BRIAN GLACKIN <[email protected]>: > This issue sounds like you have the SCALE settings for the X axis set > wrong. Check your INI files for the X and Y axes for the scale values. If > they are the same, then the problem lies elsewhere. If not, then adjust the > value 10X and remeasure. > >> >> >> 1) distance of movement on X axis is approximately 10 times less then >> >> on Y axis in situation, when i order to move the same distance on both >> >> axis. I simply enter G0 X50Y50 in MDI mode and then measure the actual >> >> movement (I have marked the starting point on the paper which is >> >> positioned on the table). I just called the technicians, they >> >> confirmed that motors and all the other mechanical parts (gearboxes >> >> etc) are the same for both - X and Y axis. >> > ------------------------------------------------------------------------------ > > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users > ------------------------------------------------------------------------------ _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
