Thanks Chris - I will try this when I get home. On 13 April 2011 09:32, Chris Morley <chrisinnana...@hotmail.com> wrote:
> > > > > So what I'm asking is, is it possible to edit the configuration in such a > > way that I can configure output pins to send a signal to enable the X/Y/Z > > axis? > > > > Cheers, > > KEv. > > This is what the 'amplifier enable' signal (in stepconf) is for. > You can actually add it to more then one parport pin if you > need more then one. > > Chris M > > > ------------------------------------------------------------------------------ > Forrester Wave Report - Recovery time is now measured in hours and minutes > not days. Key insights are discussed in the 2010 Forrester Wave Report as > part of an in-depth evaluation of disaster recovery service providers. > Forrester found the best-in-class provider in terms of services and vision. > Read this report now! http://p.sf.net/sfu/ibm-webcastpromo > _______________________________________________ > Emc-users mailing list > Emc-users@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/emc-users > ------------------------------------------------------------------------------ Forrester Wave Report - Recovery time is now measured in hours and minutes not days. Key insights are discussed in the 2010 Forrester Wave Report as part of an in-depth evaluation of disaster recovery service providers. Forrester found the best-in-class provider in terms of services and vision. Read this report now! http://p.sf.net/sfu/ibm-webcastpromo _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
