On Fri, Apr 22, 2011 at 11:02 AM, Kev James <[email protected]> wrote:
> Just got to test it. X-axis is working fine but I don't seem to be getting > any power to the y/z outputs. I have assigned amplifier enable to the three > enable pins for the three axes. I get about 1.5v across A/!A and B/!B for > the X axis, but 0 for the Y and Z. > > Does this sounds like a hardware problem to you? If so I will see if I can > find someone who knows about electronics to try and help me narrow this > down. > > Does the board have adjustable POTs for each axis? Perhaps you have them set to zero for the Y/Z axes and that is the reason?? > Cheers, > KEv. > > > On 13 April 2011 10:02, Kev James <[email protected]> wrote: > > > Thanks Chris - I will try this when I get home. > > > > > > On 13 April 2011 09:32, Chris Morley <[email protected]> wrote: > > > >> > >> > >> > >> > So what I'm asking is, is it possible to edit the configuration in > such > >> a > >> > way that I can configure output pins to send a signal to enable the > >> X/Y/Z > >> > axis? > >> > > >> > Cheers, > >> > KEv. > >> > >> This is what the 'amplifier enable' signal (in stepconf) is for. > >> You can actually add it to more then one parport pin if you > >> need more then one. > >> > >> Chris M > >> > >> > >> > ------------------------------------------------------------------------------ > >> Forrester Wave Report - Recovery time is now measured in hours and > minutes > >> not days. Key insights are discussed in the 2010 Forrester Wave Report > as > >> part of an in-depth evaluation of disaster recovery service providers. > >> Forrester found the best-in-class provider in terms of services and > >> vision. > >> Read this report now! http://p.sf.net/sfu/ibm-webcastpromo > >> _______________________________________________ > >> Emc-users mailing list > >> [email protected] > >> https://lists.sourceforge.net/lists/listinfo/emc-users > >> > > > > > > ------------------------------------------------------------------------------ > Fulfilling the Lean Software Promise > Lean software platforms are now widely adopted and the benefits have been > demonstrated beyond question. Learn why your peers are replacing JEE > containers with lightweight application servers - and what you can gain > from the move. http://p.sf.net/sfu/vmware-sfemails > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users > ------------------------------------------------------------------------------ Fulfilling the Lean Software Promise Lean software platforms are now widely adopted and the benefits have been demonstrated beyond question. Learn why your peers are replacing JEE containers with lightweight application servers - and what you can gain from the move. http://p.sf.net/sfu/vmware-sfemails _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
