Scott, it does sound like you have exact same 1100M package as me. I was lucky when I purchased mine and a friend from Florida had the phone number for the Anilam Service Tech when I had a tuning problem. He spent 45 minutes on the phone with me tuning the amps mostly with a voltmeter and a screwdriver. I'm going to the other shop today (where the Anilam is located) and I'll bring my notes back that I tried to take while talking on the phone and tuning the amps. There might be some useful info on the amps in there.
I've not looked as close at mine as you have but the encoder is shared by both the drive and the controller? I'll take some photos of my cabinets and put them on the forum later. John On 8/17/2011 2:48 PM, Scott Hasse wrote: > John: Thanks, I'm hoping the documentation will turn out to be useful. > We got the mill second or third hand, so we don't have the conversion > information. Do you know if you can see the tuning parameters in the > Anilam control software? Even with the following error at 1 inch it > eventually hits following error. > > This Anliam mill has the velocity feedback going directly to the servo amps, > both for EMC2 and Anilam control (I did not change that wiring). I have > rotary encoders only. ------------------------------------------------------------------------------ Get a FREE DOWNLOAD! and learn more about uberSVN rich system, user administration capabilities and model configuration. Take the hassle out of deploying and managing Subversion and the tools developers use with it. http://p.sf.net/sfu/wandisco-d2d-2 _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
