Has anyone tried to play a video file from something like a Gopro camera is there a enough power to play these type of files ? Or isn't there enough video or cpu power to do this I have costumer that is asking if I could put something together that would play the files after their done recording and they don't want to spend the money on a laptop
-----Original Message----- From: Fox Mulder [mailto:quakem...@gmx.net] Sent: Monday, April 22, 2013 2:47 PM To: emc-users@lists.sourceforge.net Subject: Re: [Emc-users] "Cubieboard: available at 49$" (was: LinuxCNC would be very nice on the UDOO board.) How about the Cubieboard for 49$ from http://cubieboard.org/ ? It uses a Cortex-A8@1GHz (Allwinner A10 SoC with FPU and SIMD) with 1GB DDR3@480MHz and 4GB onboard flash memory. The other onboard goodies are HDMI 1080p, 100MBit network, USB host, 96 GPIO (with I2C, SPI, RS232, ADC, ...), uSD, OpenGL ES GPU, Sata II port, IR receiver. It runs Android and other linux distros without problems. I own one from the original indiegogo campaign (like kickstarter) but until now i had not much time to do something useful with it. It would be nice if it also could be used for linuxcnc. :) Ciao, Rainer Am 19.04.2013 06:26, schrieb Gregg Eshelman: > The UDOO is a single board computer with a 1ghz quad core CPU plus an Arduino DUE. Same CPU as the Raspberry Pi but with 4 cores. > > Runs Linux and Android. > > http://www.kickstarter.com/projects/435742530/udoo-android-linux-ardui > no-in-a-tiny-single-board > > Note the much saner port arrangement than what's on the RasPi with its ports on all sides and sticking out at apparently random distances. Except for power input and Micro SD slot, UDOO's ports are all on one side and flush with each other, which will make case design much easier. > > Port LinuxCNC to the ARM i.MX6 Freescale CPU and have it communicate to/through the Arduino and use a motor controller plugged into the Arduino pin header sockets. > > At 4.33 inch x 3.35 inch (11 cm x 8.5 cm) this would make a very compact control system for CNC. The motor drivers and power supply would dwarf it. ---------------------------------------------------------------------------- -- Precog is a next-generation analytics platform capable of advanced analytics on semi-structured data. The platform includes APIs for building apps and a phenomenal toolset for data science. Developers can use our toolset for easy data analysis & visualization. Get a free account! http://www2.precog.com/precogplatform/slashdotnewsletter _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users ------------------------------------------------------------------------------ Precog is a next-generation analytics platform capable of advanced analytics on semi-structured data. The platform includes APIs for building apps and a phenomenal toolset for data science. Developers can use our toolset for easy data analysis & visualization. Get a free account! http://www2.precog.com/precogplatform/slashdotnewsletter _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
