Open a terminal and type "dmesg" to see what went wrong. On 2013/06/25 09:01 AM, Gregg Eshelman wrote: > Just trying to run LinuxCNC to have a look at it and it won't even run. I > also tried the latency test and nothing at all happens, *nothing*, not even > an error message. Just got done with a fresh install off the 2.5 disk then > updated to 2.5.2. I first tried one of the simulation setups, then tried > gantry-hs. Then I tried the wizard setup and kept clicking forward until it > was done. I just want to have a look around to get a feel for the program. > > I get this same fail to run every time. > > 2.5 did this same thing, I was hoping 2.5.2 would fix whatever is wrong. > > The PC is a Dell Dimension L1000R 1.0 Ghz Pentium III with 512 meg RAM and an > 80 gig hard drive. > http://gdgt.com/dell/dimension/l1000r/specs/ > > > ------------------------------------------------------------------------------ > This SF.net email is sponsored by Windows: > > Build for Windows Store. > > http://p.sf.net/sfu/windows-dev2dev > > > _______________________________________________ > Emc-users mailing list > Emc-users@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/emc-users
-- Regards / Groete Marius D. Liebenberg MasterCut cc Cel: +27 82 698 3251 Tel: +27 12 743 6064 Fax: +27 86 551 8029 Skype: marius_d.liebenberg --- avast! Antivirus: Outbound message clean. Virus Database (VPS): 130624-2, 2013/06/24 Tested on: 2013/06/25 09:09:40 AM avast! - copyright (c) 1988-2013 AVAST Software. http://www.avast.com ------------------------------------------------------------------------------ This SF.net email is sponsored by Windows: Build for Windows Store. http://p.sf.net/sfu/windows-dev2dev _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
