The error is in your log:

[  216.183331] RTAI[hal]: ERROR, LOCAL APIC CONFIGURED BUT NOT 
AVAILABLE/ENABLED.

and a good description (including a fix) can be found here:
http://wiki.linuxcnc.org/cgi-bin/wiki.pl?TroubleShooting#emc2_doesn_t_run_missing_lapic

Regards,
Alex

----- Original Message ----- 
From: "Gregg Eshelman" <g_ala...@yahoo.com>
To: <emc-users@lists.sourceforge.net>
Sent: Tuesday, June 25, 2013 10:01 AM
Subject: [Emc-users] Why doesn't LinuxCNC run? Error log attached.


> Just trying to run LinuxCNC to have a look at it and it won't even run. I 
> also tried the latency test and nothing at all happens, *nothing*, not 
> even an error message. Just got done with a fresh install off the 2.5 disk 
> then updated to 2.5.2. I first tried one of the simulation setups, then 
> tried gantry-hs. Then I tried the wizard setup and kept clicking forward 
> until it was done. I just want to have a look around to get a feel for the 
> program.
>
> I get this same fail to run every time.
>
> 2.5 did this same thing, I was hoping 2.5.2 would fix whatever is wrong.
>
> The PC is a Dell Dimension L1000R 1.0 Ghz Pentium III with 512 meg RAM and 
> an 80 gig hard drive.
> http://gdgt.com/dell/dimension/l1000r/specs/


--------------------------------------------------------------------------------


> ------------------------------------------------------------------------------
> This SF.net email is sponsored by Windows:
>
> Build for Windows Store.
>
> http://p.sf.net/sfu/windows-dev2dev


--------------------------------------------------------------------------------


> _______________________________________________
> Emc-users mailing list
> Emc-users@lists.sourceforge.net
> https://lists.sourceforge.net/lists/listinfo/emc-users
> 


------------------------------------------------------------------------------
This SF.net email is sponsored by Windows:

Build for Windows Store.

http://p.sf.net/sfu/windows-dev2dev
_______________________________________________
Emc-users mailing list
Emc-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-users

Reply via email to