On Fri, 2 Aug 2013, andy pugh wrote:
Date: Fri, 2 Aug 2013 14:08:48 +0100
From: andy pugh <[email protected]>
Reply-To: "Enhanced Machine Controller (EMC)"
<[email protected]>
To: "Enhanced Machine Controller (EMC)" <[email protected]>
Subject: Re: [Emc-users] 5i23 firmware trick
On 2 August 2013 11:56, Viesturs L??cis <[email protected]> wrote:
So I did a little search in email archives, found svsttp6_6.bit firmware
file that was prepared by Peter few years ago (I built a machine that is
still using it), copied it to /lib/firmware/hm2/5i23 folder and changed the
firmware file name in INI file.
Does that have the right pinout for the 7i39?
--
atp
If you can't fix it, you don't own it.
http://www.ifixit.com/Manifesto
I would check the dmesg for pinout differences. The 3PWMGen has a fault input
thats wired in some configurations, If this fault pis is ever active, it will
disable the 3PWMGen outputs. Ao if this is brought out on the FPGA pins
you may have to do either of two things:
1. If you are not using the GPIO pin, change the 3PWMGEN fault polarity
so the default state of the pin does no cause a fault
2. If you are using the GPIO pin, you will need a config that doesn't bring
out the fault pin
Peter Wallace
Mesa Electronics
------------------------------------------------------------------------------
Get your SQL database under version control now!
Version control is standard for application code, but databases havent
caught up. So what steps can you take to put your SQL databases under
version control? Why should you start doing it? Read more to find out.
http://pubads.g.doubleclick.net/gampad/clk?id=49501711&iu=/4140/ostg.clktrk
_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users
