On Tue, 6 Aug 2013, propcoder wrote: > Date: Tue, 06 Aug 2013 22:55:41 +0300 > From: propcoder <marius.alks...@gmail.com> > Reply-To: "Enhanced Machine Controller (EMC)" > <emc-users@lists.sourceforge.net> > To: emc-users@lists.sourceforge.net > Subject: [Emc-users] MESA 8i20 and enable signal > > I am starting new config with MESA 5i23, 7i49 and 8i20. I use latest dev > version. > > Despite real and described in manual 8i20 pinout differences, I managed > to run servo motor. So, the first question: why manual and pinout differs?
Which pinout differences? I am not aware of any > > Another strange thing I noticed is that 8i20 does not react to enable > input. I drive it with 12V (Enable in + and Enable in -), but it does > not makes sense. It turns on at LinuxCNC startup and turns off at > LinuxCNC shutdown instead. I almost fried my motor, thinking the drive > was turned off. That should not be. We made a change in enable and enable masks recently for an OEM and possible broke something or have a dependence on EEPROM setup that we should not have. We should have updated firmware tommorow that fixes the enable > > I couldn't find any input pin on 8i20 for enable too. > > > ------------------------------------------------------------------------------ > Get 100% visibility into Java/.NET code with AppDynamics Lite! > It's a free troubleshooting tool designed for production. > Get down to code-level detail for bottlenecks, with <2% overhead. > Download for free and get started troubleshooting in minutes. > http://pubads.g.doubleclick.net/gampad/clk?id=48897031&iu=/4140/ostg.clktrk > _______________________________________________ > Emc-users mailing list > Emc-users@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/emc-users > Peter Wallace Mesa Electronics (\__/) (='.'=) This is Bunny. Copy and paste bunny into your (")_(") signature to help him gain world domination. ------------------------------------------------------------------------------ Get 100% visibility into Java/.NET code with AppDynamics Lite! It's a free troubleshooting tool designed for production. Get down to code-level detail for bottlenecks, with <2% overhead. Download for free and get started troubleshooting in minutes. http://pubads.g.doubleclick.net/gampad/clk?id=48897031&iu=/4140/ostg.clktrk _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
