On 5 April 2014 12:42, Bill Brettle <billbret...@gmail.com> wrote: > computer. There are some example on how to do this in an LCNC document > titled Stepper Configuration. (with part of that document Attached) When I > put that into my HAL file I get an error message as shown on the top line > of that attachment.
"BillsMill.hal:24: parameter or pin 'parport.0.pin-09-invert' not found" The parameter is actually called: parport.0.pin-09-out-invert You omitted the "out" You will have the same problem a few lines later with pin 01. -- atp If you can't fix it, you don't own it. http://www.ifixit.com/Manifesto ------------------------------------------------------------------------------ _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users