if you look at the rear of the 5i25 , their should be a sticker , saying what version of firmware is flashed to the 5i25 , it will probably say as an example 7i76x2 , we will need this to help further
i'm guessing that it will be something similar or the same , and in this case shows the card has 7i76 firmware loaded this by default uses the addon- 7i76 pin layout , where if you are only using the 5i25 will need a different firmware loading into the 5i25 using the mesaflash windows utility program On 17 September 2014 04:20, Jeff Epler <[email protected]> wrote: > Newer mesa cards, such as the 5i25, store the FPGA firmware in a flash > chip. This can be changed by use of the mesaflash program, which should > be available via the package manager if it is not preinstalled. > > The mesa manual (the pdf you can get at mesanet.com) describes how to > use mesaflash at the commandline (terminal). > > If the FPGA firmware does not match what is assumed by pncconf, then the > resulting configuration file won't load. > > This is in contrast to older mesa cards which required the firmware to > be uploaded to them each time linuxcnc was started. With these cards, > pncconf would write a configuration file that would load the correct > firmware each time. > > Jeff > > > ------------------------------------------------------------------------------ > Want excitement? > Manually upgrade your production database. > When you want reliability, choose Perforce > Perforce version control. Predictably reliable. > > http://pubads.g.doubleclick.net/gampad/clk?id=157508191&iu=/4140/ostg.clktrk > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users > ------------------------------------------------------------------------------ Want excitement? Manually upgrade your production database. When you want reliability, choose Perforce Perforce version control. Predictably reliable. http://pubads.g.doubleclick.net/gampad/clk?id=157508191&iu=/4140/ostg.clktrk _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
