That gets back to my earlier post where there seems to be some mismatch in naming. If others are using 2.6.3 though I would expect if it was an issue it would have been found some time ago? This is what PnCConf created, not anything I modified.
Searching the halcmd show I find: float OUT 10 motion.spindle-speed-out-abs ==> spindle-vel-cmd-rpm-abs float 0 spindle-vel-cmd-abs ==> hm2_5i25.0.7i76.0.0.spinout I find no connection between spindle-vel-cmd-rpm-abs which shows 10 (full speed) and spindle-vel-cmd-abs which shows zero. Is it as simple as rpm missing in the nameing? ------Original Mail------ From: "andy pugh" <[email protected]> To: "Enhanced Machine Controller (EMC)" <[email protected]> Sent: Thu, 18 Sep 2014 23:39:16 +0100 Subject: Re: [Emc-users] New to LinuxCNC and PnCConf and need some help... On 18 September 2014 22:52, <[email protected]> wrote: > The original spindle issue remains, no operation at all from within linuxCNC, > despite normal operation from the PnCConf test. :( Is there a value on the motion.spindle-speed-abs pin? Is that value finding its way to the attached signal, and is that value making its way to 5i25....spinout ? -- atp If you can't fix it, you don't own it. http://www.ifixit.com/Manifesto ------------------------------------------------------------------------------ Slashdot TV. Video for Nerds. Stuff that Matters. http://pubads.g.doubleclick.net/gampad/clk?id=160591471&iu=/4140/ostg.clktrk _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users ------------------------------------------------------------------------------ Slashdot TV. Video for Nerds. Stuff that Matters. http://pubads.g.doubleclick.net/gampad/clk?id=160591471&iu=/4140/ostg.clktrk _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
