On 8/12/15 3:54 AM, andy pugh wrote: > On 12 August 2015 at 08:39, <[email protected]> wrote: >> I can control spindle speed using AXIS UI buttons or S G-command > ... >> motion.spindle-speed-out is output pin and it's not writeable. > > I think that the + / - buttons in Axis basically issue G-code "S" commands.
The +/- buttons in Axis send "increase spindle speed" and "decrease spindle speed" commands to linuxcnc. You can cause halui to send these commands by poking the halui.spindle.increase or halui.spindle.decrease pins. -- Sebastian Kuzminsky ------------------------------------------------------------------------------ _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
