> On Nov 20, 2015, at 11:46 AM, andy pugh <bodge...@gmail.com> wrote: > > n 18 November 2015 at 17:49, Jeshua Lacock <jes...@3dtopo.com> wrote: >> Long story short; I had to install a new PCI Parport card and I am trying to >> figure out what address to use for my hal configuration file for Axis. The >> card has the same CH382L chip listed in the wiki: >> >> http://wiki.linuxcnc.org/cgi-bin/wiki.pl?WCH > > It isn't clear to me what that Wiki page is for. It doesn't say that > it works. It doesn't say that it doesn't work.
Well I found that section of the wiki from folks on the list discussing PCI cards that “just work”. To me, it doesn’t make sense to me to list cards in the wiki that aren’t supported unless specifically state so (eg don’t buy this card), otherwise I interpret them as being supported by the project. Again; just my interpretation. Best, Jeshua Lacock Founder/Engineer <3DTOPO.com> GlassPrinted.com ------------------------------------------------------------------------------ _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
