On Friday 25 December 2015 23:28:01 Jack Coats wrote: > I am looking on the best way to connect my NEMA 17 steppers to the > Stepper drivers. > > I am contemplating either direct wiring (just solder, tape, heat > shrink tube) each wire back to the screw terminals on the stepper > driver. > > Second option is using connectors, DIN (screw attach cover) or Molex > push connectors near the stepper, and near the controller box where > the stepper drivers reside. > > Suggestions? > Where I have a well contained driver box setup, I am in favor of the 4 pin, screw on connector used as a mic connector on the older J.A.Pan made CB radios. Male panel mount, matching female cable pairs can be had for under a $2 bill from some sites, with some even throwing in China Post for free. Decent connector for the sheckles, and won't come unplugged unless you unscrew the lock ring on the female. > Thanks in advance. ... Jack in TN > > ---------------------------------------------------------------------- >-------- _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users
Cheers, Gene Heskett -- "There are four boxes to be used in defense of liberty: soap, ballot, jury, and ammo. Please use in that order." -Ed Howdershelt (Author) Genes Web page <http://geneslinuxbox.net:6309/gene> ------------------------------------------------------------------------------ _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
