ooops bad link Here's abetter example http://www.digikey.com/catalog/en/partgroup/d-1744-series/2069
2015-12-27 12:30 GMT+01:00 Peter Rosenblom <[email protected]>: > I use alot of of soldersleavves at work with good result. They are > heatshrinks that has a soldderband inside. you heat them up as a regular > heatshrink, and then kjeep jeating some more until the soldder metlts/wets. > Really handy and makes for very good splices. Pare it up with a > chemresistand glue-heatshrink and you a a very resilliand splice. Is does > require a decent heatgun an get good repeteabillity though. > > > http://www.te.com/usa-en/products/harnessing/interconnect-devices/soldersleeve-shield-terminators.html?tab=pgp-story > > /Peter > > 2015-12-27 11:54 GMT+01:00 andy pugh <[email protected]>: > >> On 27 December 2015 at 06:55, Bruce Layne <[email protected]> >> wrote: >> > or you can >> > epoxy coat the inside of the outer piece of heat shrink over soldered >> > connections, and when you shrink it the epoxy oozes out the ends and >> > makes a waterproof seal. >> >> Or you can buy heat-shrink with hot-melt glue pre-installed. A lot >> more convenient and not that much more expensive. >> >> http://uk.rs-online.com/web/p/heat-shrink-cold-shrink-sleeves/4811797/ >> >> -- >> atp >> If you can't fix it, you don't own it. >> http://www.ifixit.com/Manifesto >> >> >> ------------------------------------------------------------------------------ >> _______________________________________________ >> Emc-users mailing list >> [email protected] >> https://lists.sourceforge.net/lists/listinfo/emc-users >> > > ------------------------------------------------------------------------------ _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
