On Thursday 21 July 2016 09:16:58 Ralph Stirling wrote: > Perhaps a video would be unnecessary, but some photos > would sure help us curious folk better visualize your setup. > It sounds like a very handy system you rigged up, and not > very difficult. > > Thanks,
I'll take the camera out and shoot a few pix. And put it up on my web page this evening if my back allows. The target of all this is retaining the function of the crossfeed handle when the screw and nut have been replaced by a ball screw and hooked up to linuxcnc, on a 64 yo Sheldon 11x36 lathe. Cheers, Gene Heskett -- "There are four boxes to be used in defense of liberty: soap, ballot, jury, and ammo. Please use in that order." -Ed Howdershelt (Author) Genes Web page <http://geneslinuxbox.net:6309/gene> ------------------------------------------------------------------------------ What NetFlow Analyzer can do for you? Monitors network bandwidth and traffic patterns at an interface-level. Reveals which users, apps, and protocols are consuming the most bandwidth. Provides multi-vendor support for NetFlow, J-Flow, sFlow and other flows. Make informed decisions using capacity planning reports.http://sdm.link/zohodev2dev _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users