Hi gene, I may have come in too late: i.e. Day late and a dollar short. Welcome to the real world. IIUC you want a slot. EDM and a copper disk should do this quite nicely. Hope you get something working.
Dave On 07/20/2016 10:29 AM, Gene Heskett wrote: > On Wednesday 20 July 2016 13:12:09 andy pugh wrote: > >> On 20 July 2016 at 17:34, Rick Lair <r...@superiorroll.com> wrote: >>>> http://www.mcmaster.com/#=13d62q6 >>> Bad link, just goes to Mcmasters main page, >> Search for "slitting saws" then. > I don't have a mill spindle with the torque enough to turn one of those > at a good enough feed rate to keep it cutting clean, and slow enough it > won't burn dull in seconds. Thats why I didn't consider it the last > time this was discussed. > > Thanks. So I am off to inventory what I have, and can use. For a k2 > container, I have an empty dishwasher packet container, should be plenty > big enough. And disposable in the burn pit when I'm done, k2 and all. > > Cheers, Gene Heskett ------------------------------------------------------------------------------ What NetFlow Analyzer can do for you? Monitors network bandwidth and traffic patterns at an interface-level. Reveals which users, apps, and protocols are consuming the most bandwidth. Provides multi-vendor support for NetFlow, J-Flow, sFlow and other flows. Make informed decisions using capacity planning reports.http://sdm.link/zohodev2dev _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users