On 02/04/2017 02:16 AM, Bengt Sjölund wrote: > Jon, you do all op in one shot! > > It mills the hole and cuts the thread in a helical motion with feed rate > to suite material. > > Works very well as intended in recommended materials, done some > threading in steel but in pre-drilled holes with this tool. > > > I use combo drill-taps in thin materials, and they are great. Twist drills have the helical flutes to pull the chips out of the hole. The device under discussion doesn't seem to have those, so how does it keep the chips from clogging the hole?
Jon ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, SlashDot.org! http://sdm.link/slashdot _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
