Ok then it should be some config issue, I will investigate further.
On Mon, 2017-04-10 at 05:01 -0700, andypugh wrote: > The Mesa drivers are built-in to LinuxCNC, no extra config should be needed. > Can we move this to the forum? > > -- > You are receiving this because you authored the thread. > Reply to this email directly or view it on GitHub: > https://github.com/LinuxCNC/linuxcnc/issues/256#issuecomment-292929173 ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
