On Mon, 2017-04-10 at 16:30 +0100, andy pugh wrote: > On 10 April 2017 at 15:52, Valerio Bellizzomi <vale...@selnet.org> wrote: > > Running the servo jitter test program shows a value of around 6000-7000, > > but the default is 1000000 ! > > That's because a 1mS servo thread is about right for most machines. > Just about the only time that you would need to go faster in the base > thread is if you are doing brushless motor commutation in software. >
Yes the latency-test, it shows a figure of around 6000-7000 but when I use that in the config, linuxcnc doesn't start, and the dmesg shows a consistent number of messages related to a cpu being stuck ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
