I'm using Linux and one other open source Real Time OS ("mbed" a layer over Keil RTX) in a line of robots. Using my machine tools to build parts for same.
So you use these kernel for control a multiple robot .... but the single robot use is own controller or even the controller is open source ?? Is very interesting these info .... Actually I control multiple robot using userspace Qt code .... and I project to convert my app into Qt-userspace + Qt RTAI (split my app in 2 different thread) ... with rt-ethernet for sending controlling messages ... and the mechanism of your system using Keil RTX (similar to rtos if understand it well). regards giorgio ________________________________ Da: Chris Albertson <albertson.ch...@gmail.com> Inviato: venerdì 19 maggio 2017 01.27 A: Enhanced Machine Controller (EMC) Oggetto: Re: [Emc-users] Best cam linux/open for additive manufactory I'm a long-tine Linux user, staring in the mid1990's when Linux was distributed on a set of floppy disks. Before that I remember BSD UNIX and yes even "Multics". Anyone else remember how the name "Unix" was a an editorial comment about Multics? That was in the 1980's I've been a full-time user of Linux-like software going back maybe 15 year before Linux was written. I'm using Linux and one other open source Real Time OS ("mbed" a layer over Keil RTX) in a line of robots. Using my machine tools to build parts for same. So yes, I really would like to see a linux based end to end CAD/AM workflow. It appears the one just barely exists for 3D printing. There are 3D modelers and drafting tools (Blender and FreeCAD) but the missing link is g-code generation to drive 3D metal cutting tools. The current stat of the art with Linux CAM is about where it was with PCB design before Cern tool over KiCAD. It was possible but not really practical. I doubt things will change until some one with loads of cash and no need to earn money adopts Linux based CAM and pays a full-time staff of engineers to work on it for a few years. On Thu, May 18, 2017 at 2:29 PM, Bruce Layne <linux...@thinkingdevices.com> wrote: > As I mentioned in my previous too-long email, Simplify3D is a slicing > program (more of a complete 3D printing CAM program) that runs natively > under Linux. I lean strongly in favor of Free Open Source Software, and > there are very good options as Andy mentioned, but I thought it was > worth paying -- Chris Albertson Redondo Beach, California ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users Emc-users Info Page - SourceForge<https://lists.sourceforge.net/lists/listinfo/emc-users> lists.sourceforge.net This list is for users of the Enhanced Machine Controller (EMC). Topics include how to obtain, install, configure, and use EMC, as well as other general EMC related ... ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users