On 06/04/2017 08:22 PM, tom-...@bgp.nu wrote:
I have to increase the depth a couple thou and re-cut the thread to cut it
deep enough.
Due to machine spring as well as workpiece deflection, a second pass
without even changing the X depth will take off some material. So, if
you turn it down, measure, and then feed in a few thousandths in Z and
cut again and get the desired depth, that will get you a too shallow cut
if you try to cut at the same Z depth on the next part.
Jon
------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot
_______________________________________________
Emc-users mailing list
Emc-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-users
